Are you looking for a special effect for your event?
Then Alcatech Eventtechnik has exactly the right equipment for you.
The Alcatech Colossus V1 Flame Projector is a fire projector designed specifically for flame shows. The flame projector requires as fuel 1 aerosol cartridge with a special gas mixture. The aerosol cartridge, so also flame spray can be whole simple in the device use. The Collosus flame projector can then easily be dispensed through the valves, the desired amount of gas and ignited. With this method, you can create standing flames or fireballs.
The housing of the Alcatech Collosus V1 flame projector is made of refractory metal and has a good stability. The flame projector does not need to be fixed to the ground. For controlling the Alcatech Collosus V1 flame projector you can use the DMX 512 transmission protocol. For the connection to a DMX controller has the fire projector 3 pin XLR, as well as 5 pin XLR inputs and outputs. The fire project is connected to the mains via a Powercon power plug and can then be operated directly.
Thus, the security of the Collosus V1 is secured for you, has a flame projector on a tilt protection and a safety channel.
Since the Alcatech Collosus is operated with Aersosolkartuschen, this is not subject to the guidelines of pyrotechnics. You do not need a pyrotechnics certificate for the operation.
Please always observe the safety instructions in the operating instructions and only allow the device to be operated by qualified personnel or trained persons.
Voltage: AC 230V 50Hz
Power consumption: 80W
Output: 90 °
Capacity: 1 x 400 ml
Flame height: up to 5M
Safety: anti-tilt protection, safety channel
Mode: DMX / Manual
Signal: DMX 512
DMX channels: 2
DMX connection: 3 pin / 5 pin
Safety distance: 3m / 6m
Weight: 3 kg
Dimensions: 185x185x295 mm
1 x Collosus V1 flame projector
1 x Powercon power plug
1 x 2 meter DMX cable
1 x user manual