Are you looking for a special effect for your event?
Then Alcatech Eventtechnik has exactly the right equipment for you.
The Alcatech Colossus V1 Flame Projector is a fire projector designed specifically for flame shows. The flame projector requires as fuel 1 gas cylinder with a propane / butane gas mixture. The device is connected to the gas cylinder via a gas hose. The Collosus flame projector can then easily through the high-quality valves, the desired amount of gas release and ignites the flames via a spark generator. With this method, you can create standing flames or fireballs.
The housing of the Alcatech Collosus V1 flame projector is made of refractory metal and provides good stability. The flame projector does not need to be fixed to the ground. For controlling the Alcatech Collosus V1 flame projector you can use the DMX 512 transmission protocol. To connect to a DMX controller, the Fire Projector has 3 pin XLR and 5 pin XLR inputs and outputs. The fire projector is connected to the mains via a Powercon mains plug and can then be operated directly.
To ensure sufficient safety when using the Collosus V1, the flame projector has a tilt protection and a safety channel.
Since the Alcatech Collosus is operated with Aersosolkartuschen, this is not subject to the guidelines of pyrotechnics. You do not need a pyrotechnics certificate for the operation.
Please always observe the safety instructions in the operating instructions and allow the device to be operated only by qualified personnel or trained persons.
Voltage: AC 230V 50Hz
Power consumption: 80W
Output: 90 °
Capacity: 3 Kg, 5kg, 8kg, 11Kg, 33Kg gas bottles
Flame height: up to 3M
Safety: anti-tilt protection, safety channel
Mode: DMX / Manual
Signal: DMX 512
DMX channels: 2
DMX connection: 3 pin / 5 pin
Safety distance: 3m / 6m
Weight: 3 kg
Dimensions: 185x185x295 mm
1 x Collosus V1 flame projector
1 x Powercon power plug
1 x 2 meter gas hose
1 x 2 meter DMX cable
1 x user manual